Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
Welcome Offer : Use Code WELCOME5 for 5% OFF!
Free Shipping on Most USA Orders
⚠️ California Proposition 65 Warning : Some products sold on this website may expose you to chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
For more information, visit www.P65Warnings.ca.gov.
Please Follow The Instructions Below: 1. Cut Along Inside Of Template Line. Locate On Roof Carefully. Be Certain To Avoid Ribs, Braces, And Electrical Wiring. 2. Trace Template Outline On Roof. Drill A Starter Hole In Each Corner. Avoid Defacing Headliner Inside The Vehicle. Instead, Stop Your Drill Bit Short Of The Headliner. Then, Using An Ice Pick Or Nail, Push Through The Headliner Thus Indentifying The Location Of The Headliner To Be Cut Away From The Inside. 3. With The Headliner Section Removed, Use A Metal Cutting Saber Saw To Cut Around The Perimeter Of The Vent Opening You Traced On The Roof. 4. Insert Roof Vent Into Opening To Determine If It Fits Cueout Properly. If Not, Cut Out Opening As Needed. With Roof Vent Properly Fitted To Opening, Use A Center Punch To Mark The Location On The Roof For The Vent Frame Mounting Screw Holes. 5. Remove Vent From Roof And Drill All Screw Hole Locations With A1/16 Pilot Hole. Note: If Installing A Power Or Lighted Vent , Provide Power Source Of 12 Volts Dc, Using 18 Gauge Wire. 6. Place Putty Strips Aroud Rough Opening On Roof (1.27Cm) From Edge Of Rough Opening. (Be Sure Putty Strips Cover Entire Area To Be Sealed.) Use Double Layers Of Putty Strips If Necessary To Seal Ribbed Areas. 7. Insert Vent In Rough Opening On Top Of Putty Steips. Use An Awl Or Nail To Locate And Line Up Corner Drilled Holes With The Corner Screw Holes In Vent Frame. Caution: Install Vent With Lid Hinge Side Toward Front Of Vehicle. 8. Drive Corner Screws First To Hold Vent In Place While Driving All Remaining Vent Mounting Screws, Tighten Just Enough To Compress Putty Tape.
Yes, we offer free standard shipping on all orders within the United States.
When will I receive my item?
Domestic orders typically arrive within 3-5 business days. Delivery times are estimated and may vary depending on your location, weather conditions, or other unforeseen factors.
Can I change or return my item?
We hope you love your purchase, but if you need to make a change or return your item, we’ve got you covered! You can initiate a return or exchange within 30 days of receiving your order. Please ensure the product is in its original condition and packaging. For more information on our return policy, please visit our Returns & Exchanges page.